Poor Water Quality
| Contaminant | Detected Level | EPA MCL | Health Guideline | Status |
|---|---|---|---|---|
| Lead |
10.0
|
15 ppb | 1 ppb | Warning |
Water Quality Summary
Tap water quality in Bellville, Texas (77418) receives an overall grade of D (Poor) with a score of 46 out of 100, based on analysis of EPA compliance data, contaminant testing, and violation history. This is 22 points below the Texas state average of 68. Compared to the national average (75), this area scores significantly lower. The area is served by 5 water systems providing water to approximately 6,968 people, using groundwater sources. Testing has found elevated levels of Lead that warrant attention. Over the past 5 years, water systems here have accumulated 358 violations, including 7 health-based violations.
A score of 46/100 signals poor water quality in Bellville, TX. Significant issues have been identified, which may include multiple violations, contaminant levels near or above regulatory limits, or PFAS contamination. We recommend reviewing the detailed contaminant data below, considering a certified water filter, and checking your utility's Consumer Confidence Report for the latest information.
Health Information
Lead is a toxic metal that can leach from aging pipes and plumbing fixtures.
Even low levels of lead exposure can cause developmental delays in children, kidney damage, and cardiovascular effects in adults. The EPA action level is 15 ppb, but health experts recommend no safe level of lead in drinking water.
Lead enters water primarily through corrosion of lead service lines, lead solder, and brass fixtures — especially in homes built before 1986.
If lead is detected above 1 ppb, consider using a certified lead-removal filter (NSF/ANSI 53) for drinking and cooking water. Run cold water for 30 seconds before use if water has been sitting in pipes.
Common Questions
Tap water in Bellville, Texas receives a grade of D (Poor) with a score of 46/100. This indicates significant water quality concerns based on violation history, contaminant levels, or enforcement actions. We recommend reviewing the specific contaminants detected below and considering a certified water filter.
ZIP code 77418 is served by 5 water systems using groundwater sources, providing water to approximately 6,968 people. Groundwater is naturally filtered through rock and soil, often requiring less treatment. However, it can be vulnerable to contamination from underground sources like naturally occurring arsenic, nitrates from agriculture, or PFAS from industrial sites.
Lead was detected at 10.0 ppb in Bellville, Texas. While this is below the EPA action level of 15 ppb, it exceeds the health guideline of 1 ppb recommended by health organizations. Consider a certified lead filter, especially if you have young children.
No PFAS ("forever chemicals") were detected in water systems serving Bellville, Texas during the most recent EPA monitoring period (UCMR5). However, not all water systems have been tested for all PFAS compounds, and new contamination can occur over time.
Water systems serving Bellville, Texas have received 358 violations in the last 5 years, including 7 health-based violations. Violations can range from paperwork issues (monitoring & reporting) to serious health-based violations where contaminant levels exceeded safe limits. Review the violation details above for specifics.
Based on detected contaminants (lead), residents in Bellville, Texas should consider: NSF/ANSI 53 certified filter — specifically rated for lead reduction. Pitcher filters (like Brita Longlast or PUR) and under-sink systems both work. Always look for filters with NSF/ANSI certification for the specific contaminants you want to remove.