Poor Water Quality
| Contaminant | Detected Level | EPA MCL | Health Guideline | Status |
|---|---|---|---|---|
| Lead |
6.0
|
15 ppb | 1 ppb | Warning |
Water Quality Summary
Tap water quality in Milford, Michigan (48381) receives an overall grade of D (Poor) with a score of 43 out of 100, based on analysis of EPA compliance data, contaminant testing, and violation history. This is 36 points below the Michigan state average of 78. Compared to the national average (75), this area scores significantly lower. The area is served by 9 water systems providing water to approximately 19,411 people, using groundwater sources. Testing has found elevated levels of Lead that warrant attention. Over the past 5 years, water systems here have accumulated 85 violations, including 15 health-based violations.
A score of 43/100 signals poor water quality in Milford, MI. Significant issues have been identified, which may include multiple violations, contaminant levels near or above regulatory limits, or PFAS contamination. We recommend reviewing the detailed contaminant data below, considering a certified water filter, and checking your utility's Consumer Confidence Report for the latest information.
Health Information
Lead is a toxic metal that can leach from aging pipes and plumbing fixtures.
Even low levels of lead exposure can cause developmental delays in children, kidney damage, and cardiovascular effects in adults. The EPA action level is 15 ppb, but health experts recommend no safe level of lead in drinking water.
Lead enters water primarily through corrosion of lead service lines, lead solder, and brass fixtures — especially in homes built before 1986.
If lead is detected above 1 ppb, consider using a certified lead-removal filter (NSF/ANSI 53) for drinking and cooking water. Run cold water for 30 seconds before use if water has been sitting in pipes.
Common Questions
Tap water in Milford, Michigan receives a grade of D (Poor) with a score of 43/100. This indicates significant water quality concerns based on violation history, contaminant levels, or enforcement actions. We recommend reviewing the specific contaminants detected below and considering a certified water filter.
ZIP code 48381 is served by 9 water systems using groundwater sources, providing water to approximately 19,411 people. Groundwater is naturally filtered through rock and soil, often requiring less treatment. However, it can be vulnerable to contamination from underground sources like naturally occurring arsenic, nitrates from agriculture, or PFAS from industrial sites.
Lead was detected at 6.0 ppb in Milford, Michigan. While this is below the EPA action level of 15 ppb, it exceeds the health guideline of 1 ppb recommended by health organizations. Consider a certified lead filter, especially if you have young children.
No PFAS ("forever chemicals") were detected in water systems serving Milford, Michigan during the most recent EPA monitoring period (UCMR5). However, not all water systems have been tested for all PFAS compounds, and new contamination can occur over time.
Water systems serving Milford, Michigan have received 85 violations in the last 5 years, including 15 health-based violations. Violations can range from paperwork issues (monitoring & reporting) to serious health-based violations where contaminant levels exceeded safe limits. Review the violation details above for specifics.
Based on detected contaminants (lead), residents in Milford, Michigan should consider: NSF/ANSI 53 certified filter — specifically rated for lead reduction. Pitcher filters (like Brita Longlast or PUR) and under-sink systems both work. Always look for filters with NSF/ANSI certification for the specific contaminants you want to remove.