Poor Water Quality
| Contaminant | Detected Level | EPA MCL | Health Guideline | Status |
|---|---|---|---|---|
| Lead |
10.0
|
15 ppb | 1 ppb | Warning |
| Copper |
5840.0
|
1300 ppb | 300 ppb | Exceeded |
Water Quality Summary
Tap water quality in Teller, Alaska (99778) receives an overall grade of D (Poor) with a score of 45 out of 100, based on analysis of EPA compliance data, contaminant testing, and violation history. This is 9 points below the Alaska state average of 54. Compared to the national average (75), this area scores significantly lower. The area is served by Bering St Sd - Teller Sc/Wash, a surface water system providing water to approximately 295 people. Testing has found elevated levels of Lead, Copper that warrant attention. Over the past 5 years, water systems here have accumulated 389 violations, including 9 health-based violations.
A score of 45/100 signals poor water quality in Teller, AK. Significant issues have been identified, which may include multiple violations, contaminant levels near or above regulatory limits, or PFAS contamination. We recommend reviewing the detailed contaminant data below, considering a certified water filter, and checking your utility's Consumer Confidence Report for the latest information.
Health Information
Lead is a toxic metal that can leach from aging pipes and plumbing fixtures.
Even low levels of lead exposure can cause developmental delays in children, kidney damage, and cardiovascular effects in adults. The EPA action level is 15 ppb, but health experts recommend no safe level of lead in drinking water.
Lead enters water primarily through corrosion of lead service lines, lead solder, and brass fixtures — especially in homes built before 1986.
If lead is detected above 1 ppb, consider using a certified lead-removal filter (NSF/ANSI 53) for drinking and cooking water. Run cold water for 30 seconds before use if water has been sitting in pipes.
Copper can leach into water from copper plumbing, especially in newer homes or when water is acidic.
Short-term exposure above 1,300 ppb can cause gastrointestinal distress. Long-term exposure may cause liver or kidney damage. People with Wilson's disease are especially vulnerable.
Copper pipes, fittings, and faucets are the most common source. Corrosive (low-pH) water accelerates copper leaching.
If copper levels are elevated, flush pipes by running water for 15–30 seconds before use. Reverse osmosis and distillation systems effectively remove copper.
Common Questions
Tap water in Teller, Alaska receives a grade of D (Poor) with a score of 45/100. This indicates significant water quality concerns based on violation history, contaminant levels, or enforcement actions. We recommend reviewing the specific contaminants detected below and considering a certified water filter.
ZIP code 99778 is served by 1 water system using surface water sources, providing water to approximately 295 people. Surface water systems are more susceptible to contamination from agricultural runoff, industrial discharge, and weather events, but typically undergo more extensive treatment including filtration and disinfection.
Lead was detected at 10.0 ppb in Teller, Alaska. While this is below the EPA action level of 15 ppb, it exceeds the health guideline of 1 ppb recommended by health organizations. Consider a certified lead filter, especially if you have young children.
No PFAS ("forever chemicals") were detected in water systems serving Teller, Alaska during the most recent EPA monitoring period (UCMR5). However, not all water systems have been tested for all PFAS compounds, and new contamination can occur over time.
Water systems serving Teller, Alaska have received 389 violations in the last 5 years, including 9 health-based violations. Violations can range from paperwork issues (monitoring & reporting) to serious health-based violations where contaminant levels exceeded safe limits. Review the violation details above for specifics.
Based on detected contaminants (lead, copper), residents in Teller, Alaska should consider: NSF/ANSI 53 certified filter — specifically rated for lead reduction. Pitcher filters (like Brita Longlast or PUR) and under-sink systems both work. Always look for filters with NSF/ANSI certification for the specific contaminants you want to remove.
Explore Nearby