A
93

Excellent Water Quality

Cleveland, UT 84518

Emery County · Population served: 1,452 · Data updated March 2026

Water Systems Serving This Area

🏔
NORTH EMERY SSD
Surface water · Pop. 1,452
PWSID: UTAH08007

Contaminants Detected

ContaminantDetected LevelEPA MCLHealth GuidelineStatus
Lead
5.7
15 ppb 1 ppb Warning

Water Quality Summary

Understanding Your Water in Cleveland

Tap water quality in Cleveland, Utah (84518) receives an overall grade of A (Excellent) with a score of 93 out of 100, based on analysis of EPA compliance data, contaminant testing, and violation history. This is 19 points above the Utah state average of 74. Compared to the national average (75), this area performs significantly better. The area is served by North Emery Ssd, a surface water system providing water to approximately 1,452 people. Testing has found elevated levels of Lead that warrant attention. The area has a clean violation record over the past 5 years — a positive indicator of consistent water quality management.

Your Score 93/100 A
vs State 19 pts above Utah avg (74)
vs National 18 pts above national avg (75)

What a Grade A Means

A score of 93/100 means the water supply in Cleveland, UT meets or exceeds all EPA standards with minimal issues. Contaminant levels are well within safe limits, and the water system has maintained a strong compliance record. While no water supply is guaranteed perfect at the tap due to household plumbing, this is among the best-scoring areas in the country.

Surface water: sourced from rivers, lakes, or reservoirs

Health Information

What These Contaminants Mean for You

⚠️

Lead in Your Water

Lead is a toxic metal that can leach from aging pipes and plumbing fixtures.

Health Effects

Even low levels of lead exposure can cause developmental delays in children, kidney damage, and cardiovascular effects in adults. The EPA action level is 15 ppb, but health experts recommend no safe level of lead in drinking water.

Common Sources

Lead enters water primarily through corrosion of lead service lines, lead solder, and brass fixtures — especially in homes built before 1986.

What You Can Do

If lead is detected above 1 ppb, consider using a certified lead-removal filter (NSF/ANSI 53) for drinking and cooking water. Run cold water for 30 seconds before use if water has been sitting in pipes.

Common Questions

Frequently Asked Questions

Based on EPA data, tap water in Cleveland, Utah receives a grade of A (Excellent) with a score of 93/100. This indicates the water meets federal standards and has relatively few concerns. However, individual homes may still have localized issues such as lead from old plumbing.

ZIP code 84518 is served by 1 water system using surface water sources, providing water to approximately 1,452 people. Surface water systems are more susceptible to contamination from agricultural runoff, industrial discharge, and weather events, but typically undergo more extensive treatment including filtration and disinfection.

Lead was detected at 5.7 ppb in Cleveland, Utah. While this is below the EPA action level of 15 ppb, it exceeds the health guideline of 1 ppb recommended by health organizations. Consider a certified lead filter, especially if you have young children.

No PFAS ("forever chemicals") were detected in water systems serving Cleveland, Utah during the most recent EPA monitoring period (UCMR5). However, not all water systems have been tested for all PFAS compounds, and new contamination can occur over time.

Water systems serving Cleveland, Utah have zero violations in the last 5 years. This is a positive indicator of consistent regulatory compliance and water quality management.

Based on detected contaminants (lead), residents in Cleveland, Utah should consider: NSF/ANSI 53 certified filter — specifically rated for lead reduction. Pitcher filters (like Brita Longlast or PUR) and under-sink systems both work. Always look for filters with NSF/ANSI certification for the specific contaminants you want to remove.

Explore Nearby

Water Quality in Nearby ZIP Codes