Fair Water Quality
| Contaminant | Detected Level | EPA MCL | Health Guideline | Status |
|---|---|---|---|---|
| Lead |
5.3
|
15 ppb | 1 ppb | Warning |
| Compound | Level | EPA MCL | Health Guideline | Status |
|---|---|---|---|---|
| PFBS | 13.9 ppt | 2000 ppt | 100 ppt | Below limit |
| PFBA | 10.4 ppt | No standard | 500 ppt | Unregulated |
| PFHxS | 6.9 ppt | 10 ppt | 10 ppt | Below limit |
Water Quality Summary
Tap water quality in San Angelo, Texas (76901) receives an overall grade of C (Fair) with a score of 61 out of 100, based on analysis of EPA compliance data, contaminant testing, and violation history. This is 8 points below the Texas state average of 68. Compared to the national average (75), this area scores significantly lower. The area is served by 6 water systems providing water to approximately 8,898 people, using surface water and groundwater sources. Testing has found elevated levels of Lead that warrant attention. PFAS testing detected 3 compounds, all currently below EPA limits. Over the past 5 years, water systems here have accumulated 20 violations, including 14 health-based violations.
A score of 61/100 indicates fair water quality in San Angelo, TX. While the water meets minimum federal standards, there are noteworthy concerns — either elevated contaminant levels approaching regulatory limits, a moderate violation history, or both. Residents may want to review specific contaminant data and consider targeted filtration, especially for sensitive groups like children and pregnant women.
Health Information
Lead is a toxic metal that can leach from aging pipes and plumbing fixtures.
Even low levels of lead exposure can cause developmental delays in children, kidney damage, and cardiovascular effects in adults. The EPA action level is 15 ppb, but health experts recommend no safe level of lead in drinking water.
Lead enters water primarily through corrosion of lead service lines, lead solder, and brass fixtures — especially in homes built before 1986.
If lead is detected above 1 ppb, consider using a certified lead-removal filter (NSF/ANSI 53) for drinking and cooking water. Run cold water for 30 seconds before use if water has been sitting in pipes.
Common Questions
Tap water in San Angelo, Texas receives a grade of C (Fair) with a score of 61/100. While it generally meets minimum federal standards, there are some areas of concern including violation history or elevated contaminant levels. Sensitive populations (children, pregnant women, elderly) may want to consider additional filtration.
ZIP code 76901 is served by 6 water systems using surface water, groundwater sources, providing water to approximately 8,898 people. Multiple source types mean your water may come from a blend of surface and underground sources.
Lead was detected at 5.3 ppb in San Angelo, Texas. While this is below the EPA action level of 15 ppb, it exceeds the health guideline of 1 ppb recommended by health organizations. Consider a certified lead filter, especially if you have young children.
3 PFAS compounds were detected in water serving San Angelo, Texas, but all are currently below EPA limits. While levels are within regulatory standards, some health organizations recommend minimizing any PFAS exposure. Activated carbon or reverse osmosis filters can reduce PFAS levels.
Water systems serving San Angelo, Texas have received 20 violations in the last 5 years, including 14 health-based violations. Violations can range from paperwork issues (monitoring & reporting) to serious health-based violations where contaminant levels exceeded safe limits. Review the violation details above for specifics.
Based on detected contaminants (lead, PFAS), residents in San Angelo, Texas should consider: Reverse osmosis (RO) system — most effective for PFAS, lead, and other contaminants. Always look for filters with NSF/ANSI certification for the specific contaminants you want to remove.
Explore Nearby