Good Water Quality
| Contaminant | Detected Level | EPA MCL | Health Guideline | Status |
|---|---|---|---|---|
| Lead |
5.0
|
15 ppb | 1 ppb | Warning |
| Copper |
4700.0
|
1300 ppb | 300 ppb | Exceeded |
Water Quality Summary
Tap water quality in Dry Prong, Louisiana (71423) receives an overall grade of B (Good) with a score of 73 out of 100, based on analysis of EPA compliance data, contaminant testing, and violation history. This is roughly in line with the Louisiana state average of 78. The area is served by 3 water systems providing water to approximately 8,694 people, using groundwater sources. Testing has found elevated levels of Lead, Copper that warrant attention. Over the past 5 years, water systems here have accumulated 15 violations, including 7 health-based violations.
A score of 73/100 means the water in Dry Prong, LA is generally good and meets EPA standards, with only minor areas of concern. There may be low levels of detectable contaminants or a small number of non-critical violations. Most residents can feel comfortable with their tap water quality, though basic filtration can provide an extra layer of protection.
Health Information
Lead is a toxic metal that can leach from aging pipes and plumbing fixtures.
Even low levels of lead exposure can cause developmental delays in children, kidney damage, and cardiovascular effects in adults. The EPA action level is 15 ppb, but health experts recommend no safe level of lead in drinking water.
Lead enters water primarily through corrosion of lead service lines, lead solder, and brass fixtures — especially in homes built before 1986.
If lead is detected above 1 ppb, consider using a certified lead-removal filter (NSF/ANSI 53) for drinking and cooking water. Run cold water for 30 seconds before use if water has been sitting in pipes.
Copper can leach into water from copper plumbing, especially in newer homes or when water is acidic.
Short-term exposure above 1,300 ppb can cause gastrointestinal distress. Long-term exposure may cause liver or kidney damage. People with Wilson's disease are especially vulnerable.
Copper pipes, fittings, and faucets are the most common source. Corrosive (low-pH) water accelerates copper leaching.
If copper levels are elevated, flush pipes by running water for 15–30 seconds before use. Reverse osmosis and distillation systems effectively remove copper.
Common Questions
Based on EPA data, tap water in Dry Prong, Louisiana receives a grade of B (Good) with a score of 73/100. This indicates the water meets federal standards and has relatively few concerns. However, individual homes may still have localized issues such as lead from old plumbing.
ZIP code 71423 is served by 3 water systems using groundwater sources, providing water to approximately 8,694 people. Groundwater is naturally filtered through rock and soil, often requiring less treatment. However, it can be vulnerable to contamination from underground sources like naturally occurring arsenic, nitrates from agriculture, or PFAS from industrial sites.
Lead was detected at 5.0 ppb in Dry Prong, Louisiana. While this is below the EPA action level of 15 ppb, it exceeds the health guideline of 1 ppb recommended by health organizations. Consider a certified lead filter, especially if you have young children.
No PFAS ("forever chemicals") were detected in water systems serving Dry Prong, Louisiana during the most recent EPA monitoring period (UCMR5). However, not all water systems have been tested for all PFAS compounds, and new contamination can occur over time.
Water systems serving Dry Prong, Louisiana have received 15 violations in the last 5 years, including 7 health-based violations. Violations can range from paperwork issues (monitoring & reporting) to serious health-based violations where contaminant levels exceeded safe limits. Review the violation details above for specifics.
Based on detected contaminants (lead, copper), residents in Dry Prong, Louisiana should consider: NSF/ANSI 53 certified filter — specifically rated for lead reduction. Pitcher filters (like Brita Longlast or PUR) and under-sink systems both work. Always look for filters with NSF/ANSI certification for the specific contaminants you want to remove.